1931 Chevy 5 Window Coupe

This is a video we took the first time I ever drove the car.  It had a bit of a death wobble in the front end but I ironed that out later.  It was an amazing feeling driving something that I built from a truck that was buried in the dirt for about 50 years.

This is the Coupe right before we started sanding it for paint.  I took it out for a test run and the torque converter went out.  I took these pictures after it died.

I was trying to get this car ready for the Glendive car show and the converter went out about 3 days before the show.  So I pulled the engine and transmission, replaced the converter, installed the red lexan windows, sanded and painted the body and put the floor in in 3 days.  Needless to say I made it to the carshow.

Tara made the seat cover for me.

This is a 30's Pontiac dash

These are a couple of the pictures they used in the Rebel Rodz magazine that I had a 2 page layout in.

1927 Chevrolet Frame Fabrication, Engine, Transmission Placement, 1931 Chevy Coupe Build, Pinion Angle

We cut a few inches off the rear and moved the crossmember forward

So my friend Josh came to Oregon to help me for a week.  He is a welder and would make sure the frame was done correctly.

The rearend was from a Caddilac limo and had this triangulated four link design already built in so it worked great.

Making the sparks fly!

We set the engine in place and the cowl to make sure everything was going to fit.

Here the Ford Model A front crossmember is installed to lower the front end.  You can see that the frame is fully boxed now too.  Always make your body mounts before boxing the frame, I failed to do that on this car.

The motor mounts and the transmission crossmember are installed.  I bought Model A to Chevy 350 motor mounts and modified them to fit the wider frame of a 27' Chevy.  I got a 40' Ford axle off ebay, some 39' Ford spindles off ebay then the rest of the frontend parts from Speedway Motors.

We made some upper shock mounts for the rear.

This is basically the progress Josh and I made for the week.  The transmission angle is -3 degrees and the rear differential pinion angle is +3 degrees so when the suspension compresses under acceleration the drive shaft is at 0 degrees.