Whippet Update

I had the chance to roll the Whippet out, take some pictures and take it for a test drive.

I just temporarily wired it to drive it.  I have a speedway wiring harness for it and am currently installing it.

Amazingly it drove very well and ran great.

1931 Chevy 5 Window Coupe

This is a video we took the first time I ever drove the car.  It had a bit of a death wobble in the front end but I ironed that out later.  It was an amazing feeling driving something that I built from a truck that was buried in the dirt for about 50 years.

This is the Coupe right before we started sanding it for paint.  I took it out for a test run and the torque converter went out.  I took these pictures after it died.

I was trying to get this car ready for the Glendive car show and the converter went out about 3 days before the show.  So I pulled the engine and transmission, replaced the converter, installed the red lexan windows, sanded and painted the body and put the floor in in 3 days.  Needless to say I made it to the carshow.

Tara made the seat cover for me.

This is a 30's Pontiac dash

These are a couple of the pictures they used in the Rebel Rodz magazine that I had a 2 page layout in.

1931 Chevrolet 5 Window Coupe Body

I set the body up on the firewall, it is the easiest way to square it up.

Here I started adding steel structure to the inside of the body.  Old Chevy's had wood for the body framing.  They basically made a wood frame then wrapped it in metal.

Here is the body before I chopped the roof about 4 inches.

After the chop.

You can see here the fiberglass trunk lid I bought from Speedway Motors, then I made the panel above and below the lid.

1929 Willy's Whippet, Ford Model A, Mercury Flathead,Frame Fabrication, Body Channelling, Pinion Angle, Firewall Reversal

Setting up the front suspension.  I am going to make what is called a "suicide perch" for the front axle.  If it were to fail the frame hits the ground, hence suicide.

Just a shot of how I connected the rear suspension and the rear frame section that I made.  The wheelbase is longer than a Model A and on a Model A the rear spring is directly above the rear axle.

I cut the frame horns off the Model A Frame and removed the front stock cross member, both items that easily get you a couple hundred bucks on ebay.  Money toward the project!

Here I set the pinion angle at +3 degrees for suspension compression under acceleration.

Here I have the body channelled 6 inches over the frame.

You can see the first part of the front spring perch welded on.  I later add bracing to it.

A closer view of the semi-finished suicide spring perch.  I made it tall to get the car low to the ground.

I removed the firewall to reverse it and give me the engine bay clearance I need.  Reversing is just flipping it around.

Here the firewall is reversed and welded in.  The hole in the side of the cowl is for the cowl steering which I will show later.  I cut the tops of the doors off, welded the doors shut, removed the windshield sun visor, and chopped the windshield frame about 3-1/2 inches.

I have the driver side door top folded over, you can see the original height on the passenger door waiting to be done.